Tri-tool 600RBL and 600SB Series OD Tracking Module Bedienungsanleitung PDF herunterladen (Seite 21)

Model 600 SB and RBL OD Tracking Module

92-0732 Rev. 131009

Problem: The Clamshell is slipping on the pipe or tube

The clamping pads are not in full contact with the pipe or tube.

The clamping pressure is too light.

Scale and/or other foreign material is present on the pipe or tube.

Weld seams, swelling, or bumps under the Clamping Pads are preventing full

contact.

Dull Tool Bits are causing extra force in the axial and/or radial direction.

The pipe or tube wall is too thin which allows the tube wall to ex and the

machine to move.

Problem: The hydraulic motor will not start

The hydraulic power supply is shut off.

The hydraulic motor is damaged and will not run free.

Problem: The air motor will not start

The air supply is shut off.

The air motor will not run free.

The air motor needs lubrication.

Add lubrication and do not run the air motor for a few minutes.

Then try again.

Tap on the air motor casing lightly with a piece of wood or with a soft rubber

mallet.

The vanes may be sticking.

Sand or other foreign material is in the vanes of the air motor.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

Keine Kommentare

Tri-tool 600RBL and 600SB Series OD Tracking Module Bedienungsanleitung Seite 21